Fluoride Test strips (0-10-25-50-100+ ppm)

Fluoride Test Strip

The Fluoride test strip detects Fluoride in steps of 0, 10, 25, 50, and 100ppm. This test strip is used for monitoring fluoride levels in drinking water supplied by city or townships. Too much fluoride present is harmful to humans and animals. The solution to be tested must be at a pH of 0.5 in order for this test to be accurate. This pH measure can be accomplished using concentrated Hydrochloric acid (muriatic acid) to acidify the test solution, and measured with the pH 0-1.5 test strip.

Hydrochloric acid should be available at a local hardware or pool/spa store, as well as at any chemical distributors.

NOTE: The test strip result must be adjusted to compensate for the dilution used during the acidification process.

Instructions:

1. The solution to be tested is acidified with hydrochloric acid (muriatic acid). The resultant pH must be at or below pH 0.5.
2. Dip the test strip into the pH adjusted solution for 1 second.
3. Remove and wait 10 seconds before comparing against the color chart.
4. The result must be adjusted to compensate for the dilution used during the acidification process.

Pack size: 50